Mac OS X 10.3.x/10.4.x
Installing the Optional 550-Sheet Feeder
If you install the optional 550-sheet feeder after setting up the printer, be sure to turn off the printer, unplug the
power cable, and disconnect all cables from the back of the printer before starting this task.
1 Ensure that the printer is turned off, and then disconnect all cables from the back of the printer.
2 Remove the tape and the bag holding the screws.
Do not lose the screws because you will need them later.
3 Place the optional 550-sheet feeder in the same location that the printer is located.
4 Pull tray1 out of the printer about 200 mm.
5 Hold tray1 with both hands, and remove it from the printer.
Installing Optional Accessories
Select the printer from the Printer List screen in Print Center (or Printer Setup Utility).
Click Printers on the Print Center (or Printer Setup Utility) menu bar, and select Show
Select Installable Options, and select the options that have been installed on the printer,
and then click Apply Changes.