NEC Express5800 Series User Manual page 94

From the ft server utility, click [Up] of [Bring Up/Bring Down] to the PCI module
which was stopped in the step 3, and the PCI module will be started. Once the PCI
module is started, PCI module diagnosis, mirror volume duplication and PCI module
duplication are performed.
IMPORTANT:
If BrightStor ARCserve 2000 or Backup Exec is installed, the tape will not be
recognized due to the failover of the PCI module. Thus be sure to stop the services
before starting the PCI module.
1. Start [Services] from [Administrative Tools] of [Control Panel].
2. Select a service of backup software.
3. Choose "Stop" from the "Action" menu.
4. Repeat 2 and 3 for all services of the backup software.
The PCI modules' status LEDs changes as shown below:
[Indications of the status LEDs]
Immediately after the PCI module startup until the completion of diagnosis
LED
1 CPU/IO module status LED1
2 CPU/IO module status LED2
3 DISK ACCESS LED
When duplication of disks is started after the completion of PCI module diagnosis
* The status of LEDs varies depending on the method of disk duplication.
LED
1 CPU/IO module
LED1
2 CPU/IO module
LED2
3 DISK ACCESS LED
Windows Setup and Operation 3-33
Secondary
Secondary
status -
status Green blinking
Amber or Green
blinking (when the disk
is accessed, this LED
illuminates in green)
Primary
-
- Green blinking
- Amber or Green blinking
(when the disk is accessed,
this LED illuminates in
green)
Green blinking
Amber or Green
blinking (when the disk
is accessed, this LED
illuminates in green)
-
Primary
-