NEC Express5800 Series User Manual page 133

SAS BIOS ~Adaptec SAS/SATAConfiguration Utility~
Adaptec SAS/SATA Configuration utility is used to configure the built-in SAS controller on the
motherboard. You can start it up by simple key operation during POST execution without using any
special startup disk.
IMPORTANT:
Because the server is installed with the latest version of the SCSISelect utility, your screen
display may be different from the one described in this guide. For information on options
different from those described in this guide, refer to the online help or ask your service
agent.
When you start this utility, select [Server], [Monitoring Configuration], [Option ROM
Scan Monitoring], and [Disabled]. If [Enabled] is selected, system may reboot while you
are making settings. However, set [Option ROM Scan Monitoring] to [Enabled] after
making settings.
Starting and Quitting the Adaptec SAS/SATAConfiguration utility
The following section describes the procedures from starting the Adaptec SAS/SATAConfiguration
utility to quitting the utility.
1. Power on the server.
The following message appears on the screen during POST execution.
Adaptec Serial Attached SCSI(SAS) BIOS Vx.x-x
(C) 1998-2006 Adaptec, Inc. All Rights Reserved.
Press <CTRL><A> for Adaptec SAS/SATAConfiguration Utility!
2. Press and hold down the
The Adaptec SAS/SATAConfiguration utility starts up with the "Main" menu displayed.
EMBED PBrush
key and press the
Ctrl
System Configuration 4-33
key.
A