Nec Expressbuilder Top Menu; Tools Menu - NEC Express5800 Series User Manual

Express5800 series
Hide thumbs Also See for NEC Express5800 Series:
Table of Contents

Advertisement

NEC EXPRESSBUILDER Top Menu

This subsection describes the procedures for using NEC EXPRESSBUILDER for DOS-based
with local console.
Start
Start the NEC EXPRESSBUILDER top menu following the procedure below:
1.
Turn on the powers of peripherals and then power of the server in this order.
2.
Insert the NEC EXPRESSBUILDER CD-ROM into the DVD-ROM drive of the server.
3.
After the CD-ROM is inserted, reset the system (by pressing Ctrl + Alt + Delete) or turn
off the power and then on again to restart the server.
The system is activated from the CD-ROM to start the NEC EXPRESSBUILDER.
After the NEC EXPRESSBUILDER is started, the NEC EXPRESSBUILDER top menu shown
below appears.
A
B
A Tools
Starts each of the utilities stored in the NEC EXPRESSBUILDER individually to allow the
operator to provide setup. Enables the setup without influence of installed OS.
B Help
Describes the NEC EXPRESSBUILDER. We recommend you to read through the help
before the setup.
C Exit
The NEC EXPRESSBUILDER termination screen appears.

Tools Menu

"Tools" is also intended for initial setup of the server. It permits the user to quickly create utility
support disks, run the Off-lineMaintenance Utility and system diagnostic utility, and update the
various BIOS programs.
C
Installing and Using Utilities 5-3

Advertisement

Table of Contents
loading

This manual is also suitable for:

N8800-103f, exp320hr

Table of Contents