NEC Express5800 Series User Manual page 81

3-20 Windows Setup and Operation
IMPORTANT:
 For a disk to be inserted, use a new or physically formatted disk which has the same
capacity as the disk of the corresponding slot (in this example, the disk in slot 2 of the
PCI module 0)

When a disk is inserted, a popup window asking for rebooting the system may be
displayed, but there is no need to reboot it. Select [No] and close the popup window.

Insert the replacement disk after waiting for 15 seconds or more after removing a disk.
4.
Confirm that the DISK ACCESS LEDs and the display of RDR Utility change as shown
below:
 Synchronizing
Source disk
Destination disk
RDR Virtual Disk
IMPORTANT:
The time required for synchronization varies depending on the partition size on the disk.

For 18GB partition, it takes about 16 minutes.
If there is no partition, synchronization may complete in a short period of time and the
disk may become synchronized after RDR is set.
If the system is rebooted during synchronization, the process cannot be completed. Do

not restart the system until the synchronization is completed.
 Synchronization completed
Source disk
Destination disk
RDR Virtual Disk
DISK ACCESS
LED
Amber
(Blinking)
Amber
(Blinking)
DISK ACCESS
LED
Green
(Blinking)
Green
(Blinking)
RDR Utility
Op State: State
Simplex
Syncing
Simplex
RDR Utility
Op State: State
Duplex
Duplex
Duplex
Status
Resync x percent
(x=0, 10, 20, ..., 90)
Status
None