NEC Express5800 Series User Manual page 216

5-70 Installing and Using Utilities
SCSI Bus Reset
The SCSI bus can be reset.
Select [ft] tree[PCI Module][SCSI adapter][SCSI bus] screens with the ft server utility. Open
the tree of the component for which the SCSI bus is to be reset and select the [SCSI bus] tree.
The table below shows the potential cases in which the SCSI bus is reset.
Component
SCSI Bus –
Remote: Executable from remote management PC by using NEC ESMPRO Manager
Local: Executable on local server by using ft server utility
–: Not support
Reset the SCSI bus with the ft server utility in the following procedure. NEC ESMPRO Manager
cannot reset the SCSI bus. However, because the ft server utility cannot check the setup of the SCSI
bus, check the bus state with NEC ESMPRO Manager in advance.
1.
Select the target SCSI Bus in the [ft] tree.
2.
Click the [Reset] button for [BUS Reset] in the SCSI bus screen.
The modification result can be checked in the event log.
IMPORTANT:SCSI bus reset cannot be executed for the SCSI bus with which the device is not
connected.
Remote
When a malfunction occurs in the SCSI bus to require the
bus reset.
Executable in the following module state:
Only the green LED is on

Only the green LED is on when the module is in the following
state:
Duplex

Bus reset
Local