5-46 Installing and Using Utilities
3.
Recovery from a hard disk failure
If a hard disk breaks, the defective disk should be replaced as soon as possible. This
section describes alert reports and status shown by the Data Viewer while disks are
replaced to restore mirroring.
(1) Detecting problem of a hard disk
See [1. Confirm of hard disk failure] above.
(2) Removing the hard disk
Disconnect the defective hard disk. At this time, NEC ESMPRO Agent reports the
following alert to manager. And icons related to the defective hard disk change to
warning in the data viewer.
Since the hard disk has been removed, the status of the SCSI slot will be "EMPTY."
TIPS: You can identify the new hard disk by DevicePathID (ex. 10/40/1).
When one hard disk with problem was disconnected, SCSI slot changes the status to
"Warning".
[SCSI Slot] [General]