NEC Express5800 Series User Manual page 138

4-38 System Configuration
Item
CTRL-A Message
Display
Physical Drivers
Display During Post
RAID Support
Bootable CD-
ROM/DVD-ROM
support
1. Press F6 to return to reset to controller defaults.
2. To quit, press Esc until you see the closing message (If any changes have been made, the
message asking you whether or not to save the changes is displayed.).
3. When the closing message is displayed, select [Yes] to quit SerialSelect Utility and restart the
system by pressing any key. The changes made in SerialSelect Utility are enabled after the
system is restarted.
Parameter
[Enabled]
Disabled
[Enabled]
Disabled
Enabled
[Disabled]
Enabled
[Disabled]
[ ]: factory-setting
Description
If [Enabled] is selected, the message "Press
<CTRL><A> for Adaptec SAS/SATA Configuration
Utility!" is displayed in SAS controller BIOS during
the POST. Even if this option is set to [Disabled], the
utility can be started by pressing CTRL+A after the
BIOS title of SAS controllers is displayed.
If [Enabled] is selected, connected physical devices
are displayed during the system POST. However,
depending on the device display, the time that it
takes to complete entire POST can become a few
seconds longer.
Do not set to [Enabled] since RAID is not supported.
If [Enabled] is selected, allows the system to boot
from the CD-ROM/DVD-ROM media.