Start Print Mode; Print Contrast; Ram Disk Size - Avery Dennison AP5.4 Gen II User And Service Manual

03/10 Rev. 5.05-00
xxx%
xxxx KBytes
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6

Start print mode

AP 5.4 AP 5.6
Only appears, if no I/O board is installed. Otherwise, the parameter
appears in the I/O BOARD menu.
See parameter Start print mode

Print contrast

AP 5.4 AP 5.6
Setting range: 1 to 120%; Unit interval: 1; Default setting: 60
CAUTION!
Print contrast
The parameter
It counts: „The higher the setting of
ance of the printhead". This counts even more for settings above 100%.
Therefore mind:
Always choose the lowest possible setting necessary to produce an accep-
table print result.

Ram disk size

AP 5.4 AP 5.6
A part of the printer memory can be identified as a RAM disk. The RAM disk
can be used in the same way as the Compact Flash Card, e.g. for storage of
logos or fonts.
With the parameter Ram disk size, the customer can set the size of the RAM
disk to his needs. Be aware, that RAM disk memory is not available for print
picture buildup. Use of much RAM disk memory reduces the picture buildup
rate of the printer.
Switching the printer off extinguishes the memory content! Fonts, logos
etc., which were loaded on the RAM disk, must be loaded again after
switching the printer off.
Setting range: 2048 KBytes to the maximum size, which depends on the
memory configuration and allocation of the printer; Unit interval: 128 KBytes;
Default setting: 512 KBytes
on page 102.
affects directly the life durance of the printhead.
Print contrast
is, the lower is the life dur-
Info-Printouts & Parameters
60