Dispenser Para; Dispense Mode - Avery Dennison AP5.4 Gen II User And Service Manual

03/10 Rev. 5.05-00

DISPENSER PARA

Normal 1:1 Mode
Label
Feed
Direction
Printhead
Dispensing
Edge
Printing
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
This menu appears only in AP 5.4/5.6, and only, if
Periph. device
is set to „Dispenser".

Dispense Mode

SYSTEM PARAMETER > Periph. device
Only if
Governs the run of the print-dispense procedure.
The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
The label is being dispensed while printing.
The output volume is at its maximum level.
The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25 mm) + Dispense position
Also refer to parameter
A graphic can be found under
Backing paper
a
Non-printable area with
a) Dispense position = 0
b) Dispense
c) Dispense
[15] The size of the not imprintable area in Normal 1:1 depends of the setting of parameter
"SYSTEM PARAMETERS > Dispense Position".
= „Dispenser".
PRINT PARAMETERS > Dispense position
PRINT PARAMETERS > Cut mode > Normal 1:1 mode
position < 0
position > 0
Info-Printouts & Parameters
SYSTEM PARAMETER >
AP 5.4
.
b
70
AP 5.6
.
c