Ap 5.4 Parameter - Avery Dennison AP5.4 Gen II User And Service Manual

03/10 Rev. 5.05-00

AP 5.4 Parameter

PRINT INFO PRINT PARAMETERS
Printer status Print speed
Memory status Feed speed
Font status Material type
Flashdata status 4 Material length
Service status Material width
Dottest endless Print direction
Dottest punched Punch offset
Reference label Bar code Multi.
RFID status 22 Tradit. Imaging
UPC plain-copy
EAN Readline
EAN sep. lines
Cut mode
Cut position
Double cut
Rewind direction
Rotated barcodes
Dispenseposition
X – Printadjust
Y – Printadjust
Punch mode
Punch level
1. Only with INTERF.PARAM. > NETWORK PARAM. > WEB Server = „enabled" 2. Only with BLDC firmware version V4-T36 or higher 3. Only with INTERF.PARAM. > NETWORK PARAM. > Time client = „Enabled"
4. Only with at least one data block stored in the flash memory 5. Only with rewinder 6. Only with cutter 7. Only with „AP 5.4 peripheral" 8. Only if SYSTEM PARAMETERS > Periph. device = „Tear-off edge" or
„Tear off + sensor" 10. Only with activated MONARCH LANGUAGE INTERPRETER™ 12. Only if PRINT PARAMETERS > Punch mode = „Manual" 13. Only in production mode 14. As in 13. or with a setting value
> 0 18. Only with installed RFID option 20. Only if SYSTEM PARAMETERS > Periph. device = „Dispenser" 21. Only if SYSTEM PARAMETERS > Periph. device = „Int Rewinder" 22. Only with an activated RFID
option 23. Only with I/O board 24. Not with I/O board 29. Availability depends on device configuration 30. Only with a memory card inserted
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
INTERFACE PARA
> EASYPLUGINTERPR
Interface
Spooler mode
Printer ID No.
Spooler size
Offline mode
Interface delay
13 > COM1 PORT
Baud rate
No. of data bits
Parity
6 Stop bits
6 Data synch.
6 Frame error
5
> COM3 PORT 23
8 Baud rate 23
No. of data bits 23
Parity 23
Stop bits 23
12 Data synch. 23
Serial Port Mode 23
Frame error 23
> COM4 PORT
Baud rate
No. of data bits
(INTERFACE PARA cont.) (INTERFACE PARA cont.)
Parity > OPTIONS
Stop bits RFID Option
Data synch. StandAlone Input
Frame error
> DRIVEASSIGNMENT
> USB Drive C
USB select Drive D
> NETWORK PARAM.
IP Addressassign
IP Address
Net mask
Gateway address
Port address
Ethernet speed
MAC address
SNMP agent
SNMP password 13
FTP server
FTP password 13
WEB server
WEB display refr 1
WEB admin passw. 13
WEB supervisor p. 13
Time client
Time server IP 3
Sync. intervall 3
DHCP host name
10
Info-Printouts & Parameters
SYSTEM PARAMETER
Foil end warning
Foil warn stop
Print Interpret.
Character sets
Character filter
Light sens. type
Head-sensor dist 13/14
Sens. punch-LS
Foil mode
Turn-on mode
Error reprint
EasyPlug errors
Single job mode
Head resistance
Temp. reduction
Thin line emphas 13
Voltage offset
Miss. label tol.
Gap detect mode
Periph. device
Singlestartquant
External signal
Start print mode 24
Print contrast
Ram disk size
Font downl. area
Free store size
Print info mode