Delimiter Char; Label Top; Left Position; Manual Calibrate - Avery Dennison AP5.4 Gen II User And Service Manual

03/10 Rev. 5.05-00
xxH
xxx Dots
xxx Dots
YES
xxx DPI
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6

Delimiter Char

AP 5.4 AP 5.6
Used as a parameter place marker in MLI format instructions.
Default: xx = 2C (0x2C = „Comma")

Label Top

AP 5.4 AP 5.6
Label top offset (y-offet) in dots. Equals the parameter
Y-Printadjust
, which will be ignored, when MLI printjobs are printed.
Setting range: -240 - +240; Default: 0; Step width: 1

Left Position

AP 5.4 AP 5.6
Left position offset (x-offset) in dots. Equals the parameter
X-Printadjust
, which will be ignored, when MLI printjobs are printed.
Setting range: -9999 - +9999; Default: 0; Step width: 1

Manual Calibrate

AP 5.4 AP 5.6
For endless material, the label length information is sent in the printjob. For
punched material, the label length has to be detected by activating this func-
tion.
Label length calculation for punched material.
Activate this function, if label material has changed.
Calibration should be done after changing material, when there are no
printjobs loaded in the printer.
Shortcut (in offline mode): press the feed + prog buttons simultaneously
to activate the calibration.

Resolution

AP 5.4 AP 5.6
Print resolution in dpi. A 200 dpi graphic printjob can be printed with a 300 dpi
printhead.
Setting range: 200/300 dpi; Default: 300 dpi;
Info-Printouts & Parameters
PRINT PARAMETERS >
PRINT PARAMETERS >
81