Table of Contents
Advertisement
03/10 Rev. 5.05-00
Endless
Punched
xxx mm
xxx mm
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Material type
AP 5.4
AP 5.6
Definition of the materials used. A distinction is made between reel material
and gapped material (hole gaps, self-adhesive material with register gaps).
The detected gap position corresponds to the start of the label.
The value is overwritten by the appropriate Easy Plug command when
sending label formats.
If material is to be used without gaps.
If material is to be used with gaps (default setting).
Material length
AP 5.4
AP 5.6
The material length (label length) is the distance between the gaps, meas-
ured from the front edge (beginning) of a label to the front edge of the next
label.
The value is overwritten by the appropriate Easy Plug command when
sending label formats.
Setting range: 5 mm to "max. length entry"; Unit interval: 0.1 mm
Default setting: 100 mm
Maximum length entry: dependent on the print head width and memory con-
figuration.
Material width
AP 5.4
AP 5.6
Zero position of the left border. If the printer is working in line-printer mode,
alterations can be made in millimetre units.
Setting range: "min. width" to "max. width"; Unit interval: 0.1 mm
Default setting: 100 mm
Min. width: dependent on the printer type
Max. width: dependent on print head width and memory configuration.
For detailed material width information, refer to topic section „Specifications".
Info-Printouts & Parameters
28
Advertisement
Table of Contents
