Adjust Position Of Print Head; Adjust Pressure Of Print Head - Avery Dennison ALX 720 User Manual

Operators Manual
ALX 720
Full size upper part
3.4.3

Adjust position of print head

The zero line of the print head can be varied from 2 - 13 mm of the left material edge
CAUTION! - Print head must not be plugged off!
Loose screw at centre of print head axle and set print head to required position.
Fix screw at print head
Loosen black plastic disk at foil rewind and unwind mandrel by means of 2 mm allen key
Adapt them both to position of print head zero line and tighten again
3.4.4

Adjust pressure of print head

Different material width may require different pressure of print head to material in order to
optimise the print quality.
3 grades are available.
Rotate the adjustment disk by means of a coin or screwdriver to the required position.
CAUTION! - Select pressure only as high as necessary for the best print
quality. Too high pressure may lead to damages at the print head.
4/09 Page 23
Full size lower part
Preparing the machine