Table of Contents
Advertisement
03/10 Rev. 5.05-00
Printing outside
Printing inside
x.x mm
x.x mm
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Rewind direction
AP 5.4
AP 5.6
Only with mounted and activated rewinder (
Periph. device
= „Rewinder").
Determines the sense of rotation of the optional Rewinder.
Rewind direction: The printed label is facing outside.
Rewind direction: The printed label is facing inside.
X - Printadjust
AP 5.4
AP 5.6
The zero point of the mask is moved in relation to the edge of the label on the
X- axis, i. e. lengthways to the material.
If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "X-Printadjust", the part
of the graphics which "juts out" will get lost.
Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
Maximum offset away from the edge of the label: +5.0 mm
No offset: 0.0mm
Maximum offset towards the edge of the label: -5.0 mm
Y – Printadjust
AP 5.4
AP 5.6
The zero point of the mask is moved in relation to the gap position on the
Y-axis, i. e. in the feed direction.
If the setting is changed, while the print job is stopped, the printer
recalculates the format using the changed values.
Caution with graphics, which are generated via one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphics is shifted beyond the label
border as a consequence of changing the parameter "Y-Printadjust", the part
of the graphics which "juts out" will get lost.
Setting range: -5.0 to +5.0 mm; Unit interval: 0.1mm
Default setting: 0.0 mm
Maximum offset in feed direction: +5.0 mm
No offset: 0.0mm
Minimum offset against feed direction: -5.0 mm
Info-Printouts & Parameters
SYSTEM PARAMETERS >
36
Advertisement
Table of Contents
