Table of Contents
Advertisement
03/10 Rev. 5.05-00
MLI PARAMETERS
xx
xxH
xxH
1) ZPL II is a registered trademark of ZIH Corp. ZIH Corp. and Avery Dennison (including Paxar
Corporation and its subsidiaries) are not related in any way, and ZIH Corp. has not licensed or
otherwise sponsored MONARCH® printers or Avery Dennison's MONARCH LANGUAGE
INTERPRETER™. MONARCH®, MONARCH LANGUAGE INTERPRETER, MLI are trademarks
of Paxar Americas, Inc. Avery Dennison is a registered trademark of Avery Dennison
Corporation.
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Avery Dennison's MONARCH LANGUAGE INTERPRETER™ (MLI™) helps
you use an Avery Dennison 4.4, 5.4, 64xx, ALX92X, DPM/PEM, or AP7.t
printer which was set up for use with ZIH Corp.'s ZPL II®
questions about using an Avery Dennison printer with these data streams,
please contact Service.
This section lists the ZPL II® commands that the Avery Dennison printer's
MONARCH LANGUAGE INTERPRETER™ can interpret with any special
notes, if applicable.
This menu appears only with
or „EasyPlug / MLI".
MLI is not supported in Standalone Mode.
Recommended settings:
SYSTEM PARMETER > RAM disk size
SYSTEM PARAMETER > Free store size
Darkness
AP 5.4
AP 5.6
Print contrast for MLI printjobs. This setting is modified by printjobs which
contain print contrast information. The print contrast set by
SYSTEM PARAMETERS > Print contrast
Setting range: 0-30; Step width: 1; Default setting: the Easy-Plug setting is
overtaken.
Control Prefix
AP 5.4
AP 5.6
Indicates the start of a MLI control instruction.
Default: xx = 7E (0x7E = „Tilde")
Format Prefix
AP 5.4
AP 5.6
Indicates the start of a MLI format instruction.
Default: xx = 5E (0x5E = „Caret")
SYSTEM PARAMETERS > Print Interpret.
at least 2048 Kbytes
at least 2048 Kbytes
is not influenced by this setting.
Info-Printouts & Parameters
1)
. If you have any
set to „MLI"
80
Advertisement
Table of Contents
