Table of Contents
Advertisement
03/10 Rev. 5.05-00
None
Cutter
Rewinder
Tear-off edge
Dispenser
Intern Rewinder
Tear-off + sensor
Disp. with LTSI
xx
Disabled
Singlestart
Stacker full
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Periph. device
AP 5.4
AP 5.6
After installation, options must be selected under "Peripheral device" in order
to be assured of the corresponding sensor queries and printer reactions.
CAUTION! - Selecting an incorrect option can lead to malfunctions or
damage!
No peripheral device is installed.
Sets the printer firmware to the cutter option. Selection permits access to the
cut parameters.
Sets the printer firmware to the rewinder option. Selection permits access to
the rewinder setting parameters.
Sets the printer firmware to the tear-off edge option. The punch is fed forward
to the tear-off edge.
Setting for AP 5.4/5.6 dispenser version.
AP 5.4/5.6 dispenser only: Setting for printer operation in „internal rewinder"
mode, that is operation with a deflector and without dispensing edge.
AP 5.4 only: Setting for using the dispensing edge as tear-off edge. The
punch is fed forward to the dispensing edge.
Setting for operation of a LTSI applicator, see
Singlestartquant
AP 5.4
AP 5.6
Single start quantity
Setting range: 1 to 10; Unit interval: 1
External signal
AP 5.4
AP 5.6
The parameter determines, if and how an incoming signal at the - optional -
single start connector will be interpreted.
Signal interpretation disabled.
The signal triggers the printing of a single label. This setting may be used e.g.
for printing single labels by means of a foot switch.
The signal triggers the display of a status report and stops the printer. This
setting may be used when using a stacker (= stacker full signal).
Detailed information about using start signals can be found in the user man-
ual, topic section „Advanced Applications", chapter „Printing with start sig-
nal",
Settings in the parameter menu
Info-Printouts & Parameters
Technical Manual LTSI
59
Advertisement
Table of Contents
