Table of Contents
Advertisement
03/10 Rev. 5.05-00
General Information
Firmware
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
Important setting instructions
Starting in offline mode, you get to the parameter menu by pressing the prog
button. There you can set/alter the different parameters of the printer and ac-
tivate/deactivate options.
Many Parameters provide a range within the setting can be changed with a
standard step width. By this step width, the setting is changed, if the Cut-(Ap-
ply-) or Feed button is pressed once.
The step width can be increased ten times, if the Online button is pressed
simultaneously (Cut+Online or Feed+Online).
Wait at least 10 seconds between switching the device off and on again,
otherwise any modified parameter settings are not saved.
With some parameters, false settings can result in the device being
damaged (e. g. if the print head temperature is too high). Data and/or print
orders are also deleted during formatting and with other settings.
Pay attention to the corresponding notes in the following description to
ensure that no damage occurs!
Area of application
The description counts for all devices listed in the headline of this document.
All status printouts and parameters are described in the same order as they
may appear in the parameter menu of the respective printer.
Not all of the parameters appear in each of the listed printers!
At the beginning of each parameter description can be found information
about the availability of the parameter:
Only with installed I/O board.
Fig. 1:
At the beginning of each parameter description, the availability of the parameter is
specified: Between the two lines is a list of the concerned printer types; the remark
below (arrow) quotes further conditions.
If a parameter appears in the menu of a certain printer type or not, depends
on the following, which can be read from this bar:
The printer type:
Printers, which have the parameter available in the parameter menu, are
listed between the lines. Example (see fig. 1): AP 5.4, AP 5.6.
The configuration with options and/or certain parameter settings:
Example (see fig. 1): The parameter only appears in the menuof an AP 5.4/
5.6, if the device is equipped with an board. If the remark is not assigned to
a special printer type, it is valid for all listed printers.
This description applies to all printers which are equipped with a firmware
version 7.34 Pre 4081 for AP 5.4/AP 5.6.
Info-Printouts & Parameters
AP 5.4
AP 5.6
5
Advertisement
Table of Contents
