I/O Board; Start Print Mode; Reprint Signal - Avery Dennison AP5.4 Gen II User And Service Manual

03/10 Rev. 5.05-00

I/O BOARD

Pulse falling
Pulse rising
Pulse fall/ris
Level low active
Level high active
Disabled
Enabled
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
This menu appears only if the optional I/O Board is mounted.

Start print mode

AP 5.4 AP 5.6
Only with an I/O board mounted.
Selecting a print mode. Depending on the selected mode, the input signal
START_PRINT will be interpreted differently by the I/O Board signal inter-
face. The parameter is also used for the device connected to the foot switch
jack.
SYSTEM PARAMETER > External Signal = Single Start
Make sure to select
See parameter External signal
Start Print Mode
Note: The parameter
SYSTEM PARAMETER
menu.
Preconditions: Print job is available (DATA READY), printer is in "Online"
mode, no error messages.
(Default setting) The printing of a label is triggered by a high-to-low change
of the signal at the input START PRINT. The printing occurs only after the set
delay time.
The printing of a label is triggered by a low-high change of the signal at the
input START PRINT. The printing occurs only after the set delay time.
The printing of a label is triggered by a low-high-change as well as by a high-
low change of the signal at the input START PRINT. The printing occurs only
after the
set delay time.
Labels will be printed as long as the signal at input START PRINT is held low.
Labels will be printed as long as the signal at input START PRINT is held
high.

Reprint Signal

AP 5.4 AP 5.6
Only with an I/O board mounted.
The input signal is disabled
The last printed label will be reprinted on the falling edge of the REPRINT
signal.
Preconditions:
The label to be reprinted, should be printed and dispensed.
Printer is in online mode.
If a REPRINT is triggered while the printer is in "I/O-Board Pause" mode, the
reprint will proceed as soon as the printer is switched back in online mode. Precon-
dition: in level mode START PRINT must be inactive.
Info-Printouts & Parameters
on page 85.
replaces the parameter
66
.
Signal Edge
in the