03/10 Rev. 5.05-00
XX mm
XXX
XXX
USER- / SERVICE MANUAL
AP 5.4 Gen II – AP 5.6
The diameter up to which the Pullback current is throttled down to zero
(parameter Back diameter), and the diameter, from which on the brake cur-
rent starts (parameter Brake diameter).
The parameter Pullback current sets the support current for the rewinder at
the minimum diameter of 25 mm. When the diameter of the rewound label
web reaches the set value (Back diameter), the support current will be throt-
tled down to a mimimum.
Back diameter
Pullback current diameter
See parameter
Pullback current
If the label web is loose, while it is fed back under the printhead, decrease
this value in small steps. If the material is tightened too much, increase the
value in small steps.
Setting range: 0-120 mm; Default setting: 50 mm
Brake current
Only in production mode.
SYSTEM PARAMETER > Periph. device
Only if
Sets the brake current
See parameter
Pullback current
Setting range: 0-100; Default setting: 0
Brake diameter
Only in production mode.
SYSTEM PARAMETER > Periph. device
Only if
Sets the break diameter.
See parameter
Pullback current
Setting range: 0-120; Default setting: 120
Info-Printouts & Parameters
on page 118.
= „Dispenser".
on page 118.
= „Dispenser".
on page 118.
77
AP 5.4
AP 5.6
AP 5.4
AP 5.6
AP 5.4
AP 5.6