Talk/Rf Test Measuring Screen - Agilent Technologies E6392B User Manual

Screen Reference
MANUAL TEST (Synchronous Mode)

Talk/RF Test Measuring Screen

While the Talk/RF Test step is blinking as shown in
measurements on each test item before releasing the mobile. If you select a test
item column with the CURSOR CONTROL knob, the corresponding measuring
screen is displayed making real-time measurements.
Figure 3-24 Talk/RF Test Measuring Screen
For Call End from the mobile, both of pressing the MS Release softkey and
NOTE
executing the call end from the mobile are required.
After pressing the Abort softkey, execute call end from the mobile; otherwise the
NOTE
call processing may be failed at the next measurement.
Explanation
While the Talk/RF Test step is blinking, one of the test items can be selected by
rotating and pressing the CURSOR CONTROL knob, and its measurements are
made in a real-time manner showing the changes in characteristics of the mobile
under test.
In this state, DC Current under the test item table shows the dc current consumed
at the Talk/RF Test step. RX Quality and RX Level are also shown in this place.
Procedure to obtain the Measuring screens
Step 1. Place the blinking cursor at one of the test items by rotating the CURSOR
CONTROL knob.
88
Softkey Menu
o BS Release: Executes Call End from the Test Set showing the operation
message "Processing...".
o MS Release: Shows the operation message "Executing a call end from the
mobile." for a user to take action.
o Abort: Returns to the MANUAL TEST: Stand-by screen, and then to the
initial screen with function modes.
Figure 3-24, you can make
Chapter 3