Table of Contents
Advertisement
• If the MS Call softkey is pressed, the following screen is displayed. Dial and
call from the mobile to proceed to the Talk/RF Test step. You can measure the
DC Current at Camp On stage while the MS Call step is blinking.
Step 14. Upon setting up the call setup, the Talk/RF Test screen is displayed as shown
below. IMSI, IMEI, Power Class, GSM Version, RX Quality, RX Level are shown.
For MS Call, Dialed No. is also included.
Step 15. While the Talk/RF Test step is blinking as above, you can select a test item by the
CURSOR CONTROL knob to execute its test. Place the cursor at "Peak TX
Power, Burst Timing, Power Ramp" and press the CURSOR CONTROL knob, for
example, to obtain the next screen.
Step 16. Press the Abort softkey to get other softkey menus.
Chapter 2
Testing a Dual Band Mobile with MANUAL TEST (Synchronous mode)
Using Functions
37
Advertisement
Table of Contents
