Agilent Technologies E6392B User Manual page 16

There are three test modes for the MANUAL TEST mode:
o Synchronous mode: Tests are made while the Test Set and the mobile are
o Asynchronous mode: (requires Option 002) Tests are made without
o GPRS mode: (requires Option 040) General Packet Radio Service (GPRS)
Table 1-1 Test Items available for Test Modes
Test Item
Peak TX Power
Burst Timing
Power Ramp
Phase Error
Frequency Error
Sensitivity
in BER and FER
RX Quality
RX Level
DC Current
Spectrum Monitor
• The SPECTRUM MONITOR mode (requires Option 002) allows you to
measure each radio channel's spectrum transmitted from a mobile phone. The
spans for 0 to 400 kHz and ±100 kHz, relative to the traffic channel frequency,
are provided.
• The SIGNAL GENERATOR mode (requires Option 002) generates an RF
signal with or without modulation by a PN9 pseudo-random binary sequence or
all-zero data.
Chapter 1
networked to communicate with each other. This is used to test mobile
phones during the Talk/RF Test step of a test flow, in a real-time manner.
networking the Test Set and the mobile phone with each other. This is used
to test the RF transmission characteristics of mobile phones in a real-time
manner. Therefore, the receiver related characteristics such as sensitivity,
RX quality and level are not measured.
is a GSM data service that provides higher data transfer rates. Tests are
made while the Test Set and the mobile are attached to communicate with
each other. This is used to test mobile phones during the Attached step of a
test flow, in a real-time manner.
AUTOMATIC
TEST Synchronous
Mode
MANUAL TEST
Asynchronous Mode
Signal: Burst Signal: CW
Preparing for Use
Major Functions
GPRS Mode
Power vs Time
in BLER
15