Table of Contents
Advertisement
Using Functions
Testing a Mobile with MANUAL TEST (GPRS mode)
Testing a Mobile with MANUAL TEST (GPRS mode)
The following procedure explains a test on a GSM mobile phone with the
MANUAL TEST GPRS mode, which is available with Option 040.
Step 1. Turn the Test Set on and wait for its selftest routine to finish.
Step 2. Refer to
starting the test.
Step 3. Press the MANUAL TEST softkey in the initial screen to obtain the MANUAL
TEST: Stand-by screen shown below.
Step 4. If the Test Set is equipped with Option 040, make sure that GPRS is selected
(underlined) in the Mode Sync/Async/GPRS softkey. (Note that this softkey is not
available for the Test Set without Option 040.)
Step 5. Check the differences of the test flow, three more parameters for slot
configurations, and less mobile related data fields from the MANUAL TEST
Synchronous mode. RX Quality and RX Level are not included in the Sensitivity
column in the test item table.
Step 6. Rotate the CURSOR CONTROL knob and see how the circular cursor changes its
position.
44
"Preparation for Each Test" on page 22
for the procedures required before
Step 7
Chapter 2
Advertisement
Table of Contents
