Table of Contents
Advertisement
If the Abort softkey is pressed, another softkey menu is shown to activate the
trigger mode, zooming and marker functions as shown in
Figure 3-37
Aborted: Peak TX Power/Burst Timing/Power Ramp Screen
Figure 3-38
Aborted: Peak TX Power/Burst Timing/Power Ramp Zoomed Screen
Softkey Menu 1
o Start: Begins a new measurement cycle with either single or continuous
o Trigger Sing/Cont: Toggles the trigger mode between Sing for single and
o Zoom Off/On: Toggles the zooming function between Off and On. If On is
o More (1 of 3): Displays softkey menu 2.
o Return: Returns to the initial Measuring screen as shown in
Softkey Menu 2
Chapter 3
trigger mode.
Cont for continuous modes. In the continuous mode, this softkey is
highlighted blinking until the Abort softkey is pressed. In the single mode,
this softkey is highlighted for one measurement cycle and the marker
function is available with the Knob MKR/Cursor softkey.
selected, the rising edge, from 8 bit to 0 bit, and trailing edge, between bits
147 and 155, of the Power Ramp are expanded to observe the detailed test
results as shown in
Figure
MANUAL TEST (Asynchronous Mode)
Figure
3-38.
Screen Reference
3-37.
Figure
3-35.
109
Advertisement
Table of Contents
