Measuring: DC Current
The test data for the DC Current is displayed as shown in
measurement is made at the attached state, the test result does not show any title
but it is equivalent for the connect state.
DC current can be measured only when the DC Power field is set to On and power
NOTE
is supplied from the Test Set to the mobile under test.
Figure 3-52
Measuring: DC Current
Softkey Menu 1
o Start: Begins a new test.
o Trigger Sing/Cont: Toggles the trigger mode between Sing for single and
o More (1 of 2): Displays softkey menu 2.
o Return: Returns to the initial Measuring screen as shown in
Softkey Menu 2
o Print: Allows you to print a hardcopy of a graphic image from the screen.
o More (2 of 2): Returns to softkey menu 1.
o Return: Returns to the initial Measuring screen as shown in
Chapter 3
Cont for continuous modes. In the continuous mode, this softkey is
highlighted blinking until the Abort softkey is pressed. In the single mode,
this softkey is highlighted for one measurement cycle.
Screen Reference
MANUAL TEST (GPRS Mode)
Figure
3-52. As this
Figure
3-45.
Figure
3-45.
131