Table of Contents
Advertisement
Screen Reference
SPECTRUM MONITOR
SPECTRUM MONITOR
This function mode is specialized for testing mobile phones, therefore the settings
for spectrum analysis are very much dedicated to make quick measurements.
To test mobile phones using the Spectrum Monitor, set the mobile phone to
transmit RF power independently (without sending a special command from the
Test Set to the mobile phone, for instance).
This section is applicable only for Test Sets with Option 002.
NOTE
When entering numeric values, the variable increment softkey menu is displayed.
Refer to
59.
Initial Screen
If the SPECTRUM MONITOR softkey is pressed, the spectrum screen is shown
with the frequency span in either 0 to 400 kHz or 100 kHz, along with the test
conditions and result text.
Figure 3-55
Initial Screen of Spectrum Monitor
136
"Variable Increment Softkey"
Softkey Menu 1
o Start: Begins a new test.
o Trigger Sing/Cont: Toggles the trigger mode between Sing for single and
Cont for continuous modes. In the continuous mode, this softkey is
highlighted blinking until the Abort softkey is pressed. In the single mode,
this softkey is highlighted for one measurement cycle and the marker
function is available with the Knob MKR/Cursor softkey.
o More (1 of 3): Displays softkey menu 2.
o Return: Displays the initial screen with function modes.
Softkey Menu 2
and
"Storing Two Numeric Values" on page
Chapter 3
Advertisement
Table of Contents
