Table of Contents
Advertisement
• Press the Print All softkey to print the detailed measurement results as follows.
Write the model number or name of the mobile and the customer name on the
report.
Step 26. Place the circular cursor at Pass or Fail of any channel in the Burst Timing or
Power Ramp cell, then press the CURSOR CONTROL knob to obtain the next
screen. See where the marker appears in the graph and the failed result data is
shown if any (highlighted in this text).
Step 27. Press the Return softkey to return to the previous screen.
The detailed test results for other test items can be obtained in the same manner.
Step 28. If you want to make the same test again, press the Start softkey.
If you want to change Test Sequence and Test Condition, select the
CONFIGURATION mode to obtain the Test Setup screens.
If you want to do a different test, press the Return softkey to obtain the initial
screen.
Chapter 2
Testing a Dual Band Mobile with AUTOMATIC TEST
Using Functions
33
Advertisement
Table of Contents
