Measuring Screen Examples - Agilent Technologies E6392B User Manual

Screen Reference
MANUAL TEST (Asynchronous Mode)

Measuring Screen Examples

Measuring: Peak TX Power/Burst Timing/Power Ramp
The actual measurement data are shown in enlarged numerals but the Power Ramp
result text is shown when the marker is placed at any point of its measured trace. If
the actual data exceeds the limits in the graph, one (or two for two fails) white
triangle marker indicates the failed position at the top of the graph frame. Any data
indicating a failure is highlighted.
The Burst Timing cannot be measured and its value is not displayed with the
NOTE
asynchronous mode.
While making continuous measurements, the Trigger Sing/Cont softkey is blinking
as shown in
Figure 3-36 Measuring: Peak TX Power/Burst Timing/Power Ramp Screen
108
Figure 3-36.
Softkey Menu
o Trigger Sing/Cont: Toggles the trigger mode between Sing for single and
Cont for continuous modes. In the continuous mode, this softkey is
highlighted blinking until the Abort softkey is pressed. In the single mode,
this softkey is highlighted for one measurement cycle.
o Abort: Stops continuous measurements and shows another softkey menu.
Chapter 3