Agilent Technologies E6392B User Manual page 97

Screen Reference
MANUAL TEST (Synchronous Mode)
Measuring: DC Current
NOTE DC current measurements can be executed only when the DC Power field is set to
On and dc power is supplied from the Test Set to the mobile phone.
Camp On DC Current is measured at the Camp On state for MS Call as shown in
Figure
NOTE Camp On DC Current can be measured when the MS Call softkey is pressed and
before executing the call setup from the mobile.
Talk DC Current is measured at the Talk/RF Test state as shown in
Any data indicating a failure is highlighted.
Figure 3-30 Measuring: Camp On DC Current Screen
Figure 3-31 Aborted: Talk DC Current Screen
96
3-30.
Softkey Menu
o Trigger Sing/Cont: Toggles the trigger mode between Sing for single and
Cont for continuous modes. In the continuous mode, this softkey is
highlighted blinking until the Abort softkey is pressed. In the single mode,
this softkey is highlighted for one measurement cycle.
o Abort: Stops continuous measurements and shows another softkey menu as
follows.
Figure 3-31.
Chapter 3