Table of Contents
Advertisement
Using Functions
Testing a Mobile with SPECTRUM MONITOR
Testing a Mobile with SPECTRUM MONITOR
This procedure describes a test on an E-GSM mobile phone using the SPECTRUM
MONITOR mode.
This section is applicable only for the Test Sets with Option 002.
NOTE
Step 1. Turn the Test Set on and wait for its selftest routine to finish.
Step 2. Refer to
starting the test.
Step 3. Set the mobile phone to transmit RF power.
Step 4. Press the SPECTRUM MONITOR softkey in the initial screen to obtain the next
SPECTRUM MONITOR screen.
Step 5. Rotate the CURSOR CONTROL knob and see how the circular cursor changes its
position.
At one field, press the CURSOR CONTROL knob, then rotate it. You see that field
changes its values. Press the CURSOR CONTROL knob to enter that value.
Step 6. Set the higlighted fields of the test parameters as shown in the above screen.
48
"Preparation for Each Test" on page 22
Step 6
for the procedures required before
Chapter 2
Advertisement
Table of Contents
