Initial Screen - Agilent Technologies E6392B User Manual

Initial Screen

After power on, the initial screen can be used to select one of the function modes
as shown in
the procedure selection field are shown.
To update the current firmware with the most recent one, refer to
the Firmware" on page
To recall one of the test procedures from your SRAM memory card, refer to
"Recalling a Test Setup File" on page
To return to the initial screen from any function mode, press the Return softkey
(multiple times if necessary).
NOTE For Test Sets without Option 002, the SPECTRUM MONITOR and SIGNAL
GENERATOR softkeys are not available.
Figure 3-6 Initial Screen
Softkey Menu
o AUTOMATIC TEST: Displays the AUTOMATIC TEST: Stand-by screen
o MANUAL TEST: Displays the MANUAL TEST: Stand-by screen and its
o SPECTRUM MONITOR: Displays the SPECTRUM MONITOR screen
o SIGNAL GENERATOR: Displays the SIGNAL GENERATOR screen and
Chapter 3
Figure 3-6. Also, the firmware revision name currently installed and
165.
and its softkey menu. Refer to
softkey menu. Refer to "MANUAL TEST (Synchronous Mode)" on page
80, "MANUAL TEST (Asynchronous Mode)" on page 102
installed, or "MANUAL TEST (GPRS Mode)" on page 118
is installed.
and its softkey menu if Option 002 is installed. Refer to
MONITOR" on page 136.
its softkey menu if Option 002 is installed. Refer to
GENERATOR" on page 143.
163.
"AUTOMATIC TEST" on page
"SPECTRUM
"SIGNAL
Screen Reference
Initial Screen
"How to Update
63.
if Option 002 is
if Option 040
61