Adjusting The Display Contrast; Uut Connections - Agilent Technologies E6392B User Manual

Adjusting the Display Contrast

You can adjust the display contrast by controlling the CONTRAST knob located
on the front panel.
Rotate the CONTRAST knob clockwise to cause the display background to
gradually brighten in comparison to the text on the display. If the background does
not appear to change, it is possibly set to the maximum contrast.
Rotate the CONTRAST knob counterclockwise to cause the display background to
gradually darken in comparison to the text on the display. The minimum contrast
setting is not a complete dark or black display, therefore some contrast between the
background and the text will still be visible.

UUT Connections

Connect the mobile phone under test (UUT) to the Test Set using either of the
following methods:
Using the RF Cable
Connect the RF cable, which is available as one of the options, to the RF IN/OUT
port on the front panel of the Test Set. Insert the other end connector to the mobile
phone's RF port.
Using the Antenna Coupler
Connect the Antenna Coupler connector to the RF IN/OUT port on the front panel
of the Test Set. Insert the antenna of the mobile phone into the hole of the Antenna
Coupler as deep as possible.
Using a User-Supplied Cable
If you have the cable which connects between the mobile phone's RF port and the
RF IN/OUT port of the Test Set, use it instead of the Antenna Coupler.
Using the Shield Box
Connect the Antenna Coupler In/Out connector of the shield box (Agilent
N4678A) to the RF IN/OUT port on the front panel of the Test Set. Place the
mobile phone on the antenna coupler board inside the shield box using the
horizontal and vertical holders.
Chapter 1
Preparing for Use
Preparation for Each Test
23