Table of Contents
Advertisement
Screen Reference
AUTOMATIC TEST
Screen Fields
After the Start softkey is pressed in the Stand-by screen, the measurement is
initiated and the Measuring screen is displayed.
While making a measurement, the operator must respond to operation or
instruction messages by pressing the appropriate softkeys of the Test Set, or by
pressing the mobile's keys. Also the circular cursor is not shown because you
cannot modify any of the parameter values or test conditions during testing.
One of the test flow steps blinks to show which step is currently being tested.
While the RF Test step is blinking, each of the test items blinks sequentially to
obtain a test result.
The DC Current consumed at the camp on stage is measured at the LOC. The
Update step and its result is displayed in the DC Current cells of the table in the
Measuring Detailed screen, when DC Power is set to Auto or On and dc power is
supplied from the Test Set to the mobile using the appropriate dc power cable.
The following display fields show the data from the mobile on the lower screen at
this state:
70
Display Field
Displays the International Mobile Subscriber Identity from the
IMSI:
mobile.
Displays the International Mobile Station Equipment Identity from
IMEI:
the mobile.
Displays the number dialed from the mobile.
Dialed No.:
Displays one of the defined factors. See
Power Class:
184.
Displays either Phase 1 or Phase 2 defined by the mobile.
GSM Version:
Description
"Power Classes" on page
Chapter 3
Advertisement
Table of Contents
