Security - Intergraph InterServe 80 SL System Setup

66
power but allows greatest system performance. To alter these settings, choose Customized.
To turn off power management, choose Disabled. The default setting is Customized.
NOTE Before you can change the following settings, you must set the Power Savings mode to
Customized.
Standby Timeout
This setting controls the amount of time that elapses before the system enters Standby Mode.
Standby Mode turns off various devices in the system, including the display screen, until you
start using the system again. To disable, set the standby timeout feature to Off, or select from
a range of 1 to 16 minutes.
Suspend Timeout
The Suspend Timeout setting sets the amount of time that elapses for the system to enter
Suspend Mode. Suspend Mode turns off most devices in the system, reducing power usage to
a minimum. You can disable the suspend timeout feature by setting this option to Off, or
select from a range of 5 to 60 minutes.
Resume On Time
When this setting is enabled (On), the system counts down to zero and awakes from Standby
or Suspend mode. The default setting is Off.

Security

Use this setting for additional setup menus to control the security functions of the system. To
enable, highlight the security option and press
following figure.
. A submenu displays as shown in the
ENTER