Security Menu; Supervisor, User - Intergraph InterServe 650 Setup Manual

Value
378h
278h
3B8h
Parallel Port Mode
This parameter allows you to change the parallel port mode setting. The values are Normal
(default), EPP, and ECP. If this parameter is set to EPP, the EPP version parameter displays.
EPP Version
If the Parallel Port Mode is set to EPP, you can select two EPP protocol versions: 1.7 and 1.9
(default).
Parallel Port IRQ
This parameter allows you to select a base IRQ for the parallel port. The default is IRQ-7, or
IRQ-5 may be selected. Either IRQ can be assigned to any of the LPT port numbers as shown
in the parallel port table above.

Security Menu

Supervisor, User

To prevent unauthorized users from accessing the AMIBIOS Setup program, you can enter a
password on both of the Supervisor and User menus. If you do not enter a password, then the
system will not prompt users for a password when they start AMIBIOS Setup. These
passwords do not affect the system logon password.
NOTE The Advanced Setup menu contains the Password Checking parameter that enables the
system to use the password you enter.
Parallel Port Address Range
LPT1 378-37A
LPT2 278-27A
LPT3 3BC-3BE
Interrupt
IRQ-7 or IRQ-5
IRQ-7 or IRQ-5
IRQ-7 or IRQ-5
55