Multiboot; Power Management - Intergraph InterServe 80 SL System Setup

Rack mount

Hide thumbs Also See for InterServe 80 SL:

Table of Contents

Multiboot

Use this option to display additional setup menus to configure system boot devices. Press

to display the multiboot submenu. This submenu provides the following options:

ENTER

Hard Drive

This setting tells the system to boot from the system's hard disk drive only.

NOTE

In non-RAID systems, the Hard Drive setting displays up to four drives. By default, the boot

device (that is, the first drive in the list) is the drive with SCSI ID 14 (0E in hexidecimal). This

drive is located in slot 0 (the right-most slot) in the disk drive section.

Removable Devices

This setting causes the system to boot from the specified order. To change the order, highlight

an option and use the plus or minus keys to move the option up or down in the list.

Use this option to display additional setup menus to control the power management functions

of the system. To configure, highlight the Power Management option and press

submenu displays as shown in the following figure.

Power Savings

This setting allows you to change the system power management settings. Maximum Power

Savings conserves the greatest amount of system power. Maximum Performance conserves

. A

ENTER

Table of Contents

Do you have a question about the InterServe 80 SL and is the answer not in the manual?