Utility Menu; Detect Master; Detect Slave; Security Menu - Intergraph InterServe 600 Series System Setup

Hide thumbs Also See for InterServe 600 Series:

Table of Contents

Utility Menu

The Utility Menu allows the system to detect installed IDE drives. If an IDE controller is

installed, use DetectMaster and Detect Slave to detect the IDE drives. For information on

setting an IDE device to master or slave, refer to the documentation accompanying the drive.

Detect Master searches for the master IDE device. Any IDE drive found is then made

available for you to configure.

Detect Slave searches for the slave IDE device. Any IDE drive found is then made available

for you to configure.

The Security Menu allows you to change the system password and enable or disable virus

protection.

Use Password to prevent unauthorized users from accessing the AMIBIOS Setup program. If

you do not enter a password, the system does not prompt users for a password when they start

AMIBIOS Setup. This password does not affect the system logon password.

NOTE

The Advanced Setup menu contains the Password Checking parameter that enables the

system to use the password that you enter.

To enter a password:

Select the Password icon. The Password menu displays.

Key in the characters (maximum of six) for the password.

Key in the password to confirm it.

Table of Contents

Do you have a question about the InterServe 600 Series and is the answer not in the manual?