System Power, Startup, And Shutdown - Intergraph InterServe 80 SL System Setup

u
To stop the system, perform an orderly shutdown and then push the Power button for at
least six seconds. An orderly shutdown consists of stopping all running applications and
logging off Windows NT by clicking on Start on the video screen and then selecting Shut
Down. Choose Shut down the computer, and click Yes.
If external InterRAID disk cabinets are connected to the system, always power on or off the
system as follows:
u
Turn power on to the InterRAID cabinets first, listen for the audible beep, and then turn
on power to the system base unit.
u
Turn off power to the system base unit first (as described previously), and then turn power
off to the InterRAID cabinets. If you turn power off to the InterRAID cabinets first, the
RAID controller will read the drives in those cabinets as dead the next time you turn
power on to the system. If this happens, refer to the Mylex documentation for drive
recovery procedures.

System Power, Startup, and Shutdown

When you connect the power cord from the InterServe 80 SL Rack Mount to an AC power
outlet, auxiliary power is applied to the system. Auxiliary power monitors the Power button
on the front of the system. The Power button is on the lower right side of the InterServe 80
SL Rack Mount, just below the floppy disk drive.
The Power button is not a traditional "on or off" power switch. Depending on the system's
current power state, you can use the Power button to wake up, start, or shut down the system.
See the following table for details on using the Power button.
If InterServe 80 SL
Rack Mount is...
Off (no LEDs on)
Working (green
LED on)
Unresponsive
(green LED on)
Remember the following guidelines for using the Power button:
u
After connecting the system to AC power, press the Power button momentarily (for less
than 1 second) to start the system. To shut down the InterServe 80 SL Rack Mount, use
the Automatic Shutdown Utility.
u
To power down if the system is unresponsive to mouse or keyboard actions, press and
hold the Power button for at least six seconds.
Press Power Button
Momentarily (< 1 sec)
Momentarily (< 1 sec)
And hold (> 6 sec)
To...
Start up
Run Automatic Shutdown Utility
Power down
43