Using The Mouse; Using The Floppy Disk Drive - Intergraph InterServe 80 SL System Setup

Using the Mouse

The system's mouse is a PS/2-compatible tracking device that controls the movement and
positioning of the pointer (or cursor) displayed on the screen in a graphical display
environment. The basic techniques for using the mouse are as follows:
Action
Point
Click
Double-click
Drag
Right click
NOTE The double-click speed is timed. If you double-click too slowly, the system responds as if you
clicked twice. You can adjust the double-click speed using the operating system's Mouse
application.
To use the mouse, make sure it is properly connected to the system. Place the mouse on a
clean, flat surface, such as a desktop or a mouse pad. Move the mouse across the flat surface
to move the pointer across the screen.

Using the Floppy Disk Drive

The system's floppy disk drive occupies a 3.5-inch peripheral device bay, and is accessible
through a 3.5-inch slot on the front of the base unit. The drive accepts standard 3.5-inch
720 KB and 1.44 MB diskettes.
Follow these guidelines to use the floppy disk drive:
u
To insert a diskette into the drive, position the diskette so the arrow embossed on the
diskette faces up. Slide the diskette into the floppy disk slot and through the drive door,
and push it into the drive until it clicks into place and the eject button next to the slot pops
out.
u
Before removing a diskette, ensure the drive LED is not lit. The LED lights green to
indicate floppy disk drive activity.
u
Remove the diskette by pushing the eject button adjacent to the floppy disk slot, and then
pulling the diskette out of the drive.
Description
Move the mouse to point to your selection on the screen.
Press and release the left mouse button once.
Press and release the left mouse button twice.
Press and hold the left mouse button, then move the mouse. Release the button
when you finish dragging your selection to a new location.
Press and release the right mouse button once.
49