Intergraph InterServe 80 SL System Setup page 77

Set Supervisor Password
This setting controls access to the BIOS Setup utility. Press
Password submenu. Type the password, and press
again. The password may be disabled by setting the new password to nothing (pressing
ENTER
the
ENTER
WARNING If you forget the Supervisor Password, it cannot be disabled without clearing the CMOS.
Set User Password
This setting controls access to the BIOS Setup utility. Follow the same procedure used to set
the Supervisor Password.
NOTE When a password is entered, it is saved immediately. All other changes may still be
discarded (see Exit Screen).
Password on Boot
When this setting is enabled, the system requires a password upon starting up. Either the
Supervisor or User Password may be entered. The default setting is Disabled.
Fixed Disk Boot Sector
This setting allows write protection of the boot sector of the fixed disk. The default setting is
Normal. When set for Write Protected, it serves as a form of virus protection. If the
passwords are enabled, this option may only be changed by the Supervisor.
key without first typing a password).
to display the Supervisor
ENTER
. Retype the password and press
ENTER
67