Using Monitor; Using Solo - Roland RSS M-300 Owner's Manual

SOLO MODE select buttons
1
These select the solo mode from the following choices:
ADD ON Channels whose [SOLO] are on will be mixed for
monitoring.
LAST Only the channel whose [SOLO] was turned on most
recently will be monitored.
SOLO Lev knob
2
This adjusts the solo level in a range of -Inf dB–+10.0 dB.
The solo output level is affected not only by the SOLO Lev knob,
but also by the LEVEL knob in the monitor section or by the
LEVEL knob of the PHONES jack.
3 DELAY
fig.ScrMonitorGuide3.eps
1
2
3
DELAY button
1
This turns the delay on/off.
DELAY TIME
2
This indicates the delay time in milliseconds.
DELAY knob
3
This adjusts the amount of delay in a range of 0.0ms–
400.0ms (when delay unit is millisecond).
You can select the units for the delay
4 Monitor source select buttons
These select the monitor source.
You can also assign monitor source selections to the USER
buttons (p. 136).
5 AUX/MTX SOLO follows SENDS ON FADER button
If this has a check mark, the solo of the AUX/MTX will be
turned on in tandem with SENDS ON FADER. When SENDS
ON FADER mode is turned off, the solo will be turned off.
The function buttons have the following operations:
[F1 (INPUT AFL)] Selects the point from which the signal will be
sent from the
post-pan signal of the channel will be sent. If
this is off, the pre-fader signal will be sent.
[F2 (OUTPUT AFL)] Selects the point from which the signal will be
sent from the AUX, MTX, or MAIN to solo. If this
is on, the post-fader signal of the channel will
be sent. If this is off, the pre-fader signal will be
sent.
(p. 152).
CH1–32 to solo. If this is on, the
[F8 (M-48 MANAGER)] This accesses the M-48 MANAGER popup (p.
170)

Using Monitor

1.
Access the MONITOR screen.
2.
Use the monitor source select buttons to select the
desired monitor source.
The monitor signal will be output from the output jacks to
which MONITOR OUT L/R are patched, and from the PHONES
jack.
3.
Use the MONITOR section's LEVEL knob or the PHONES
LEVEL knob to adjust the monitor output level.
By default, MONITOR L/R is patched to CONSOLE OUT
and to DIGITAL OUT. You can use the output patchbay to
change the output-destination. For details, refer to "Output
patchbay operations" (p. 92).

Using Solo

1.
Access the MONITOR screen.
2.
Use the SOLO MODE select buttons to select the desired
solo mode.
3.
On the top panel, press [SOLO] for the desired channel.
The signal of that channel will be sent to solo buses, and
output from the output jacks to which MONITOR OUT L/R are
patched, and from the PHONES jack.
4.
Use the SOLO Lev knob to adjust the solo level.
5.
Use the MONITOR section's LEVEL knob or the PHONES
LEVEL knob to adjust the monitor output level.
The M-300's solo has the following priorities:
(High) 4 Key-in solo
3 CH solo
Priority
2 DCA solo
(Low) 1 AUX/MTX/MAIN solo
Solo operates under following rules:
• Turning on higher priority solo temporary replaces
lower priority solos. It returns to lower priority solos
when higher priority solo is cleared.
• Turning on lower priority solo clears higher priority
solos.
Monitor/Solo
3/4
115