Talkback/Oscillator; About Talkback And Oscillator - Roland RSS M-300 Owner's Manual

Talkback/Oscillator

About talkback and oscillator

fig.TB-OSCFlow.eps
TALKBACK / OSCILLATOR
MIC
SELECT
CONSOLE INPUT 1
CONSOLE INPUT 2
CONSOLE INPUT 3
CONSOLE INPUT 4
OSC
FREQ LEVEL
Talkback is a function that sends the input of a mic connected to the
the output patchbay. This is useful when the mixer operator needs to convey instructions to performers on stage or to staff.
Oscillator is a function that generates a sine wave, and sends it to an
you need to measure the acoustical response of a hall, or when checking the connections of external devices. This is useful when checking
the connections of external devices.
Either talkback or oscillator can be outputted. If you turn both talkback and oscillator on, oscillator will be outputted.
TALKBACK/OSC section
Talkback and oscillator operations are performed in the
TALKBACK/OSC section.
fig.TalkbackOscSectGuide.eps
1
2
3
MIC LEVEL knob
1
This adjusts the preamp gain of
the talkback mic input.
DISP button
2
This accesses the TALKBACK/OSCILLATOR screen, where you
can make talkback settings and oscillator settings.
TALKBACK button
3
This turns talkback on/off. It will be lit when talkback is on.
112
TALKBACK / OSC
OSC ON
TALKBACK
LEVEL
the CONSOLE IN selected as
TALKBACK / OSC OUT
ON
OSC ON
TO OUTPUT PATCHBAY
CONSOLE IN1–4 on the rear panel jack to an
AUX, MTX, MAIN L/R/C, or the output
Accessing the TALKBACK/OSCILLATOR
screen
Talkback settings are made in the TALKBACK tab of the
TALKBACK/OSCILLATOR screen.
1.
In the TALKBACK/OSC
fig.ScrTalkbackGuide.eps
2
3
The TALKBACK/OSCILLATOR screen will appear.
1 Meters
These indicate the level of the talkback/oscillator,
and MAIN.
2 TALKBACK MIC
fig.ScrTalkbackGuide2.eps
1
MAIN AUX MTX
LR C 1 2 3 4 5 6 7 8 1 2 3 4
LRC 1 2 3 4 5 6 7 8 1 2 3 4
MAIN AUX MTX
AUX, MTX, MAIN L/R/C, or
patchbay. This is useful when
section, press [DISP].
1
4
AUX, MTX,
2
3
4
5