Roland RSS M-300 Owner's Manual page 176

Management of the M-48 live personal mixer
PAN knob
4
This adjusts the source's panning in a range of L63–C–R63.
Fader
5
This adjusts the source's level in a range of -Inf dB – +10.0 dB.
Group
6
Shows a group to which a source is assigned.
If a source is not assigned to any groups, that shows "--."
"Source Assign settings" (p. 178)
The function buttons have the following operations:
[F1 (SOURCE LAYOUT)] Switches to the SOURCE LAYOUT tab.
[F2 (M-300 LAYOUT)] Switches to the
[F3 (COPY MIX LEVEL)] Accesses the COPY MIX LEVEL popup, where
you can copy the M-300's mix levels to
sources (p. 177).
[F5 (SOURCE ON FADER)] If this is on, you'll be able to use the top panel
faders to adjust the source levels.
[F7 (RESET)] Resets the source level/pan settings (p. 176).
[F8 (CLOSE)] Closes the popup.
Accessing the M-48 SOURCE LEV/PAN
popup
1.
Access the desired M-48 SETUP popup.
fig.ScrM48Setup.eps
2.
Press [F3 (SOURCE LEV/PAN)].
fig.ScrM48SrcLev1.eps
The M-48 SOURCE LEV/PAN popup will appear.
176
M-300 LAYOUT tab.
3.
Verify that the desired M-48 is shown in the target unit
indication.
If the wrong unit is selected, press [F8 (CLOSE)] to close the
popup; then re-select the target and return to step 2.
4.
Use [F1 (SOURCE LAYOUT)] or [F2 (M-300 LAYOUT)] to
select the display that you prefer.
Editing the source level/pan settings
1.
Access the desired M-48 SOURCE LEV/PAN popup.
fig.ScrM48SrcLev1.eps
2.
Move the cursor to the faders and pan knobs of sources
1–40, and use the value dial to edit the values.
3.
If you want to use the M-300's top panel faders to control
the levels, turn [F5 (SOURCE ON FADER)] on.
The display in the M-300 LAYOUT tab will switch in tandem
with the M-300's channel layer buttons.
Resetting the source level/pan settings
1.
Access the desired M-48 SOURCE LEV/PAN popup.
fig.ScrM48SrcLev1.eps
2.
Press [F7 (RESET)].
fig.ScrM48SrcLevClr_Conf.eps
A message will ask you to confirm the operation.
3.
Press [F8 (RESET)] to reset the source level/pan settings
and close the popup.
The parameters of each source will be set to the following