Roland RSS M-300 Owner's Manual page 151

USB MIDI settings
To make USB MIDI settings, use the USB MIDI tab of the REMOTE
popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F4 (REMOTE)] to access the REMOTE popup.
3.
Press [F2 (USB MIDI)].
fig.ScrSysRemoteUSBGuide.eps
2
1
3
The USB MIDI tab will appear.
1 Dev ID knob
This specifies the device ID of the M-300 in a range of 1–32.
This setting is common to the MIDI tab, the USB MIDI tab,
and the V-LINK tab.
2 RECEIVE select buttons
These buttons select the items that USB MIDI will receive.
FADER, MUTE Change (CC)
SCENE Change (PC)
Sys Ex
MMC
3 SEND select buttons
These buttons select the items that USB MIDI will transmit.
FADER, MUTE Change (CC)
SCENE Change (PC)
Sys Ex
4.
Move the cursor to the Dev ID knob and specify the
device ID.
5.
Move the cursor to the RECEIVE select buttons for each
item that you want USB MIDI to receive, and press
[ENTER] to select the button.
6.
Move the cursor to the SEND select buttons for each item
that you want USB MIDI to transmit, and press [ENTER] to
select the button.
Fader and mute changes
(control changes)
Scene changes
(program changes)
System exclusive
MMC for the USB memory recorder
Fader and mute changes
(control changes)
Scene changes
(program changes)
System exclusive
RS-232C settings
The RS-232C tab of the REMOTE popup is used to make RS-232C
settings.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F4 (REMOTE)] to access the REMOTE popup.
3.
Press [F4 (RS-232C)].
fig.ScrSysRS232CGuide.eps
1
2
The RS-232C tab will appear.
1 MIDI/RS-232C selection indicator
This shows the status of the rear panel MIDI/RS-232C select
switch.
The functionality of the selected connector(s) is active.
MIDI
RS-232C
Always make sure to switch off the M-300's power before
you change the setting of the MIDI/RS-232C select switch.
2 RS-232C rate select buttons
These buttons specify the RS-232C communication speed.
Choose the setting that matches the speed setting on your
computer.
4.
In the MIDI/RS-232C select indication, verify the status of
the rear panel MIDI/RS-232C select switch.
5.
Move the cursor to the RS-232C rate select button that
matches the communication speed of your computer,
and press [ENTER] to select the button.
Remote
MIDI is selected.
RS-232C is selected.
151