Roland RSS M-300 Owner's Manual page 59

For details, refer to "Limiter operations" (p. 78).
3 Insert indication
fig.ScrChInsOut.eps
FX INS
1
If FX1–FX4 are inserted, the number of the inserted FX is
shown here.
If the number is shown in white, the effect insertion is
enabled. If it is shown in gray, effect insertion is bypassed.
If you move the cursor to FX INS and press [ENTER], the
EFFECTS screen will appear.
Inserting an effect into a channel is done in the EFFECTS screen.
For details, refer to "Inserting an effect into a channel" (p. 101).
Up to four effects can be inserted into one channel. In this case,
they will be inserted in series, in order of the FX number.
EXT FX
2
If an external effects processor is inserted, this shows the
number of the inserted EXT FX.
By moving the cursor to EXT FX and pressing [ENTER], you
can access the EXTERNAL INSERT screen.
Inserting an external effects processor into a channel is done in
the EXTERNAL INSERT screen. For details, refer to "Inserting an
EXT FX into a channel" (p. 107).
4 8-band EQ
fig.ScrChEQ.eps
1
3
4
6
7
8
2
5
AUX, MTX, MAIN operations
EQ button
1
This turns the 8-band EQ on/off.
OL (Overload) indicator
2
This will light when the output of the 8-band EQ exceeds the
OVER Lev setting specified in the METER SETUP popup (p.
96).
8-band EQ graph
3
This shows the approximate response of the 8-band EQ.
Band 1 type
4
You can select on of the following filter types:
LSV low-shelving
PEAK peaking
HPF high-pass filter
Band 8 type
5
You can select one of the following filter types:
HSV high-shelving
PEAK peaking
LPF low-pass filter
Q
6
This adjusts the Q in a range of 0.36–16.00. Higher values
produce a sharper curve.
FREQ
7
This adjusts the center frequency in a range of 20Hz–
20.0kHz.
GAIN
8
This adjusts the gain in a range of -15.0dB–+15.0dB.
For details, refer to "8-band EQ operations (AUX/MTX/MAIN)" (p.
82).
59