Roland RSS M-300 Owner's Manual page 150

Remote
V-LINK settings
To make V-LINK settings, use the V-LINK tab of the REMOTE
popup.
1.
In the SETUP section, press [SYSTEM] to access the
SYSTEM screen.
2.
Press [F4 (REMOTE)] to access the REMOTE popup.
3.
Press [F3 (V-LINK)].
fig.ScrSysRmtVLnkGuide.eps
1
2
The V-LINK tab will appear.
1 V-LINK button
Turns the V-LINK function on/off.
2 Dev ID knob
This specifies the device ID of the M-300 in a range of 1–32.
This setting is common to the MIDI tab, the USB MIDI tab,
and the V-LINK tab.
3 SOURCE field 1–8
Here you can specify the channels that will correspond to V-
LINK sources 1–8, and the maximum level and minimum
level for each channel.
fig.ScrSysRmtVLSrcGuide.eps
1
2 3
V-LINK SOURCE CHANNEL SELECT popup button
1
This accesses the V-LINK SOURCE CHANNEL SELECT popup,
where you can select the channel that corresponds to each
source.
MAX Lev knob
2
This specifies the level when the source level is at the
maximum (100%), in a range of -Inf dB–+10.0 dB.
MIN Lev knob
3
This specifies the level when the source level is at the
150
3
minimum (0%), in a range of -Inf dB–+10.0 dB.
4.
Move the cursor to the Dev ID knob and specify the
device ID.
5.
Move the cursor to the V-LINK SOURCE CHANNEL SELECT
popup button for the desired source, and press [ENTER].
fig.ScrSysVlnkSrcSel.eps
4 5
The V-LINK SOURCE CHANNEL SELECT popup will appear.
4 Current V-LINK source channel indication
This indicates the current V-LINK source channel.
5 Applicable V-LINK source indication
This indicates the V-LINK source to which the settings of the
V-LINK SOURCE SELECT popup will apply.
6 SOURCE CHANNEL select buttons
These buttons select the channel that will correspond to the
source.
The function buttons have the following operations:
[F6 (SELECT NONE)] Clears the source channel selection.
[F8 (CLOSE)] Closes the popup.
6.
Move the cursor to the desired channel, and press
[ENTER] to select it.
If you're using a stereo source, specify one of the stereo-linked
channels.
7.
Press [F8 (CLOSE)] to close the V-LINK SOURCE CHANNEL
SELECT popup.
8.
Move the cursor to the MAX Lev knob in the desired
SOURCE field, and use the value dial to specify the
maximum level of the channel.
9.
Move the cursor to the MIN Lev knob in the desired
SOURCE field, and use the value dial to specify the
minimum level of the channel.
10.
Move the cursor to the V-LINK button and press [ENTER]
to turn it on.
6