Roland RSS M-300 Owner's Manual page 201

LO-MID FREQ
Center frequency of the Lo-Mid band (*1)
Value: 20 Hz–20.00 kHz
LO-MID Q
Steepness of the frequency response curve at the Lo-Mid band
center frequency (*1)
Value: 0.36–16.00
HI-MID TYPE
Filter type for the Hi-Mid band (*1)
Value: PEAK, LSV, HSV, LPF1, HPF1, LPF2, HPF2,
BPF, BEF, THRU
HI-MID GAIN
Gain of the Hi-Mid band (*1)
Value: -15.0–+15.0 dB
HI-MID FREQ
Center frequency of the Hi-Mid band (*1)
Value: 20 Hz–20.00 kHz
HI-MID Q
Steepness of the frequency response curve at the Hi-Mid band
center frequency (*1)
Value: 0.36–16.00
HI GAIN
Gain of the Hi band
Value: -15.0–+15.0 dB
HI FREQ
Center frequency of the Hi band
Value: 20 Hz–20.00 kHz
(*1) Depending on the Type setting of each band, there are
certain combinations for which the Freq, Gain, and Q values
will have no effect, as listed below.
PEAK (Peaking)
Creates a hill or valley in the region of FREQ.
Freq: Valid Gain: Valid
LSV (Low Shelving)
Boosts/cuts the region below FREQ
Freq: Valid Gain: Valid
HSV (High Shelving)
Boosts/cuts the region above FREQ
Freq: Valid Gain: Valid
LPF1 (Low-Pass Filter 1)
Passes the frequency region below FREQ
Freq: Valid Gain: —
HPF1 (High-Pass Filter 1)
Passes the frequency region above FREQ
Freq: Valid Gain: —
Q: Valid
Q: —
Q: —
Q: —
Q: —
LPF2 (Low-Pass Filter 2)
A sharper response curve than LPF1
Freq: Valid Gain: —
HPF2 (High-Pass Filter 2)
A sharper response curve than HPF1
Freq: Valid Gain: —
BPF (Band Pass Filter)
Passes the frequency region around FREQ.
Freq: Valid Gain: —
BEF (Band Eliminate Filter)
Removes the frequency region around FREQ
Freq: Valid Gain: —
THRU (Thru)
Passes all frequency regions
Freq: — Gain: —
Appendix
Q: Valid
Q: Valid
Q: Valid
Q: Valid
Q: —
201