Roland RSS M-300 Owner's Manual page 123

By holding down [SHIFT] and pressing [ ] or [ ], you can
quickly move the cursor between the name edit field and M-48
MEMORY.
You can press [F6 (MEMORY LIST)] to access the M-48 MEMORY
LIST popup, where you can view the M-48's memory names.
5.
Press [F8 (STORE)].
fig.ScrSceneStore_Conf.eps
A confirmation message will ask you to confirm the Store
operation.
If the user preference CONFIRMATION select button "SCENE/LIB
STORE" is unchecked, the Store operation will be executed
without showing the confirmation message.
6.
Press [F8 (STORE)] to execute the Store operation.
The operation will be cancelled if you press [F7 (CANCEL)].
If you want to exclude a specific M-48 unit from the memory store
operation, use the M-48's MEMORY SAFE function (p. 171).
M-48 MEMORY LIST popup
To access the M-48 MEMORY LIST popup, press the SCENE STORE
popup's [F6 (MEMORY LIST)] button. Here you can verify the
memory name of the M-48's storage destination.
fig.ScrM48MemList_Guide.eps
1
1 Unit indication
This indicates the M-48 unit that is the object of the M-48
MEMORY LIST popup.
2 Memory list
This indicates the memory number and name.
The memory of the current memory number is shown in green.
2
The function buttons have the following operations:
[F1 ( PREV UNIT)] Change the target unit.
[F2 (NEXT UNIT )]
[F7 (MEMORY SAFE)] Turns the MEMORY SAFE function on/off for the
target M-48 unit.
[F8 (CLOSE)] Closes the popup.
Synchronizing M-48 recall operations
For each scene memory, you can specify whether M-48 memories
will be recalled, and also specify the memory number that the M-
48 units will recall.
When you recall the scene that contains this setting, each M-48
will recall its memory (except for M-48 units whose MEMORY
SAFE function (p. 171) is on).
1.
Access the RECALL PARAMETER EDIT popup for the
desired scene.
fig.ScrRecallParam.eps
2.
In the M-48 MEMORY area, add a check mark to the
RECALL button and specify the memory number
1
fig.ScrM48MemRecall_Guide.eps
1 2
3.
Press [F8 (OK)] to finalize the change and close the
popup.
If you press [F7 (CANCEL)], your changes will be cancelled and
the popup will close.
If you want to exclude the memory of a specific M-48 unit from
recall, use the M-48's MEMORY SAFE function (p. 171).
Scene memory
.
2
123