Editing Other User Preferences - Roland RSS M-300 Owner's Manual

Editing other user preferences

1.
Access the USER screen.
fig.ScrUser.eps
2.
From the user list, select the desired user.
3.
Press [F6 (USER PREF)].
The USER PREFERENCE popup will appear.
4.
Press [F5 (OTHER)] to access the OTHER tab.
fig.ScrUserPrefGuide.eps
1
2
5 6
The OTHER tab will appear.
1 Applicable user indication
This indicates the user settings to which the USER
PREFERENCE popup applies.
CONFIRMATION select buttons
2
These buttons select the operations for which a CONFIRM
popup will appear. When you perform an operation for
which the corresponding button is selected here, a CONFIRM
popup will appear, asking you to confirm the operation.
This area contains the following items:
SCENE/LIB STORE Scene or library store operations
SCENE/LIB RECALL Scene or library recall operations
PATCHBAY CHANGE Changes to the input/output patchbay
3 CHANNEL SELECT operation select buttons
These buttons choose the way in which channel selection
will occur. The channel selection mode whose button is
selected will be used.
You can choose one of the following three channel select
3 4
7
modes:
Channel SELECT [SOLO] will select the channel.
follows SOLO
button
Channel SELECT The selected channel for each layer is
changes with Layer remembered, and button operations in the
Selection layer section will change the
selected channel.
CHANNEL DISPLAY Pressing [SEL] will access the CHANNEL
follows CH SELECT DISPLAY screen.
button
4 SHIFT LOCK select buttons
These change the behavior of the SHIFT button. [SHIFT] will
light if SHIFT is on:
OFF SHIFT will be on only while you hold down
[SHIFT].
ON SHIFT will alternately turn on or off each time
you press [SHIFT].
ONCE SHIFT will turn on when you press [SHIFT],
and will turn off when you execute a
function associated with SHIFT.
5 HOME SCREEN select buttons
Use these to select the Home screen (p. 33). You can choose
one of the following:
CHANNEL DISPLAY The CHANNEL DISPLAY screen will be the
home screen.
METER The METER will be the home screen.
6 STARTUP OPTION select buttons
This makes the setting for the state in effect on powerup.
The selection items are as indicated below:
Recall SCENE Selecting this check box causes the scene of
the specified number to be recalled on
powerup.
USER LAYER Selecting this check box causes the user
layer of the specified number to be selected.
7 DCA [SEL] select buttons
This selects the operation that pressing [SEL] performs when
DCA1 through 8 has been called up to the top panel's fader
module section (p. 21). The selection items are as indicated
below:
OFF [SEL] is disabled.
ASSIGN The DCA GROUP ASSIGN popup (p. 108) is
accessed.
5.
Move the cursor to the desired item, and press [ENTER] to
change it.
6.
Press [F8 (OK)] to finalize the USER PREFERENCE changes
and close the popup.
If you press [F7 (CANCEL)], the changes will be cancelled and
the USER PREFERENCE popup will close.
User settings
137